Planning tool
Notched, drilled or cut beam?
Draw the beam, tell us what it carries and where it was cut, and see whether it still meets code, and whether a retrofit can fix it.
The same check we run on Bay Area homes, now in your hands.

One we saw: a garage beam notched in the middle for the door opener.
Draw the beam
Its length and where it is supported: posts, walls or other beams.
Tell us what it carries
Draw it on a map of your home for an estimate, or enter your engineer's loads.
Add the cuts
Notches, holes and tapers, and see right away whether each one meets code.
Good to know
Can a beam be notched or drilled?
Sometimes. The code allows small holes and notches in set places, and the makers of engineered beams publish their own rules. A notch in the middle of a span, on the bottom edge, is where it hurts most.
What is a retrofit?
Steel plates or a new piece of wood, fastened to the beam to give back what the cut took out. When a cut doesn't meet code, the tool says whether one is possible; we design it.
Do I need to sign up?
No. Save your beam to come back to it, or send it to us when you'd like an engineer to look at it.
What happens next?
When your check is done, send it to us with a few photos using ‘Send to an engineer’. We’ll look it over and reach out to discuss retrofit ideas and the next steps for your contractor and permit.